Skip to content

Network Setup

Configure WiFi on your pyDirect device.

Using ScriptO Studio

  1. Go to scriptostudio.com or use the embedded IDE
  2. Click Onboard New Device from the landing page
  3. Connect your device via USB and click Connect Device
  4. Select Change WiFi from the scenarios
  5. A modal displays available networks with signal strength
  6. Select your network and enter the password
  7. Device connects and saves settings
  8. You're returned to the scenarios screen

[!NOTE] Changing WiFi only updates network settings. To generate new certificates, use Re-provision Device afterward.

Network Selection Modal

The network selection shows:

  • Network name (SSID) - The name of the WiFi network
  • Signal strength in dBm - e.g., -49 dBm is excellent, -70 dBm is fair, -90 dBm is weak
  • Lock icon - Indicates the network requires a password

After Changing WiFi

After WiFi is configured, you're returned to the scenarios screen where you can:

  • Disconnect - If you just needed to update network settings
  • Re-provision Device - If you need new HTTPS certificates

Troubleshooting

Network not appearing?

  • Make sure the network is broadcasting its SSID (not hidden)
  • Move device closer to the router
  • Try rescanning by going back and selecting Change WiFi again

Connection fails?

  • Verify the password is correct
  • Check if MAC filtering is enabled on your router
  • Ensure you're connecting to a 2.4 GHz network (ESP32 doesn't support 5 GHz)

Wrong network saved?

Simply run Change WiFi again to select a different network.